Slitting Line Of High Degree Of Automation

- Sep 04, 2017 -

Slitting line, also known as slitting machine, sub-machine, cutting machine, scissors. Mainly used for tinplate, galvanized iron, silicon steel, cold-rolled strip, stainless steel, aluminum, steel and other coil material slitting shear. Is the metal coil cut into the required width of the various materials, Slitting Line and then the strip into a small volume for the next step to use, is the transformer, the motor industry and other metal strip precision cutting of the necessary equipment.

The slitting line is used to roll the metal coil through uncoiling, slitting, and winding into a roll of the required width. Applicable to the processing of cold-rolled plate, hot-rolled plate, galvanized sheet, aluminum, stainless steel plate, color coated plate and the surface coated with various types of metal coil.

Slitting line mainly with the loading trolley, uncoiler, leveling machine, slitting machine, waste side winder, tensioning machine, winding machine, unloading device and other components.

Slot line with PLC centralized controller, man-machine interface display, Slitting Line a high degree of automation, simple and reliable operation.

Slitting line Features:

The equipment is made up of loading trolley, unwinding, feeding, Slitting Line disc blade slitting machine, damping pre-dosing, winding unit, unloading trolley, control system and so on.

The main function is to cut a wider metal roll along the length of the required width of the strip.

For the rolling, punching, cold forming, Slitting Line stamping and other processes to prepare blank.

By adjusting the distance between the upper and lower knife shaft to accommodate different thickness of the plate.

Replace the different specifications of the blade spacer, spacer sets, Slitting Line can be divided into different width strip.

Slip line in the installation of the need to pay attention to the problem:

1. Slotting line should be careful after power, if the facilities abnormal anti-inflammatory drugs immediately stop and appropriate treatment

2. Non-staff is strictly prohibited near the facilities in operation

3. The slitting line uncoiler can not be reversed

4. When the facility is in operation, Slitting Line no one can cross the rotating sheet

5. Each time in the knife, you must use gasoline to clean the tool and the upper and lower shaft

6. Facilities are checked on Wednesdays and Saturdays to check if all fastening bolts are loose and take appropriate measures


Related Products