Slitting line Features:
Slitting line is made by loading trolley, unwinding, feeding, disc blade slitting machine, damping pre-material, winding unit, unloading car, control system.
The main function is to cut a wide metal roll along the length of the required width of the strip.
For the rolling, punching, cold forming, Slitting Line stamping and other processes to prepare blank.
By adjusting the distance between the upper and lower knife shaft to accommodate different thickness of the plate.
Replace the different specifications of the blade spacer, spacer sets, Slitting Line can be divided into different width strip.
Slitting line is mainly used for tinplate, galvanized iron, silicon steel sheet, cold rolled strip steel, stainless steel belt, aluminum belt, strip and other coil material slitting. Slitting Line Is the metal coil cut into the required width of the various materials, and then the strip into a small volume for the next process to use, is the transformer, the motor industry and other metal strip precision cutting of the necessary equipment.
Applicable industry: mainly for transformers, motors, home appliances, automobiles, building materials, packaging and other industries.
This large-scale equipment production line, whether it is in the machine before the operation of the preparatory work or in the operation of the details of the operation and after the use of maintenance work is very important, we explained before the slitting line before the operation of the five Item preparation work, Slitting Line today we mainly explain the operation of the slitting line of the Notes and the details of the work
1, carefully, carefully read the drawings, according to the provisions of the input width, length and other data and audit. Adjust the rail width, Slitting Line punch position and pile table position as required.
2, to measure the actual width of the material to be cut silicon steel sheet, measuring accuracy of 0.05 mm, test the film width tolerance, S degree and wave degrees, Slitting Line shall not exceed the standard.
3, feeding, manual test cut, take the film, after checking the drawings can be automatically cut after the test.
4, the cutting process, the operator should pay close attention to the transmission parts of the operating conditions, once the phenomenon of jamming, immediately stop processing.
5, the normal work of the equipment, the arm and other parts of the body do not reach into the pile of materials and other parts of the transfer to prevent accidents, such as adjustments should be carried out in the shutdown state.
6, equipment, equipment, equipment, do not place tools, materials and other debris.
7, the use of traffic up and down the volume, we must operate in accordance with the provisions, beware of accidents.
8, lifting products must be adjusted when the balance of the material, Slitting Line slow slow down to prevent the slide wounding.
9, scrap basket full of waste when the timely replacement.
10, the process of work, Slitting Line if the device should be abnormal downtime immediately, notify the equipment maintenance personnel, and make a record. Please fill in the shift record carefully.